Renaming right-side (backup) volume

English Support for Syncovery on Windows.
Post Reply
hartfilms
Posts: 2
Joined: Mon Nov 16, 2026 11:23 pm

Renaming right-side (backup) volume

Post by hartfilms »

As the attached .pdf shows, 4 of my profiles (CIC WD Media, Glyph A, Glyph B and Glyph C) have lost the volume letter to the RightPath which are 4 separate external 7200rpm USB 3.0 backup drives. If there was nothing on those drives, I would rename them in Windows Disk Management, but I am being cautious because that might conflict with the Syncovery protocol.

I am wondering if I should just "Edit" each profile. I can browse via File Explorer from the profile to locate its backup. Or is it better to create new Profiles. All of these worked the last time I backed up.

I couldn't find any advice in Best Practices or among Support topics here. I should add that all profiles were created in Windows 10 Pro and now I am in 11 Pro.

Thank you for your attention.
Jayasri
Attachments
Syncovery Profiles.jpg
Syncovery Profiles.jpg (176.03 KiB) Viewed 1488 times
tobias
Posts: 2286
Joined: Tue Mar 31, 2020 7:37 pm

Re: Renaming right-side (backup) volume

Post by tobias »

Hello,
Syncovery isn't very sensitive here. You can do it as you wish. As long as Syncovery finds the destination, it will be fine.

To avoid the depenency on drive letters (which can change), you can instead type the volume label into Syncovery.

For example, you can replace
E:\FolderName
with
CIC WD Media:\FolderName

If that is the drive's volume label. Then Syncovery will find the drive regardless of drive letter.
hartfilms
Posts: 2
Joined: Mon Nov 16, 2026 11:23 pm

Re: Renaming right-side (backup) volume

Post by hartfilms »

Thank you very much, Tobias. I hope this helps others.
Post Reply